4.5 (670) · $ 21.50 · In stock
This is one that's had me stumped for a while. In another slicer (S3D), I can set the first layer to be different (hotter) than the following layers. For example, with PLA, I would usually do the first layer 5 C hotter, then on layer 2, reduce it. The Setting seems to point to something I just ca
Initial First layer expansion Cura 4.0 - UltiMaker Cura
Cura 3.5 - First Layer Issues - UltiMaker Cura - UltiMaker
Material flow challenges? - Materials & profiles - UltiMaker
Small Layer Printing Temperature · Issue #14812 · Ultimaker/Cura
/wp-content/uploads/2023/05/ultimaker
Temp gcode not in start gcode of Cura? - UltiMaker Cura
Cura 4.0.0] - Wrong first layer temperature · Issue #5380
Extra Retraction at Start - UltiMaker Cura - UltiMaker Community
Improving 3D Printed Models - Ultimaker Cura - Tutorial Australia
Initial layer temperature not set in 4.11? (SOLVED) - UltiMaker
Filament change at layer - Page 2 - UltiMaker Cura - UltiMaker
Confusion over the initial layer temperature? : r/Cura
Ultimaker Cura Now Available Page UltiMaker Cura UltiMaker , 40% OFF
Tips & Tricks - Build Plate Adhesion
Ultimaker Cura 5.1 arrives with metal FFF printing, better