4.9 (632) · $ 13.99 · In stock
Hi all, I am currently trying to inflate boundary layer of 1st layer < 1e-5. When I try to make the inflation layer smaller, the layer did not grow. I tried using both relative and absolute size and also played with the advance options. Can you give me some feedback on what I did wrong? From the mesh log, I can see that the inflation layer is as intended and after “Selecting externalDisplacementMeshMover displacementMedialAxis” there is some iteration that causes the layer not to grow. This
What are the best meshing tools for CFD? - Quora
Your Guide to Meshing Techniques for Efficient CFD Modeling
7 Questions to Ask CAE Vendors of Structural Analysis and Simulation Software
794 questions with answers in MESH
Week 3 - External flow simulation over an Ahmed body.
The emerging role of open technologies for community-based improvement of cryopreservation and quality management for repository development in aquatic species - ScienceDirect
Inflation Layer - Project Support - SimScale CAE Forum
SimScale - Another Fine Mesh
Boundary layer in parametric mesh - Project Support - SimScale CAE Forum
F1 front wing CFD thesis Inflation layer problem - Project Support - SimScale CAE Forum
Simulation Software – Page 8