• Home
• contour print
• slicing - How to print the outer contour before inner lines with Cura? - 3D Printing Stack Exchange

slicing - How to print the outer contour before inner lines with Cura? - 3D Printing Stack Exchange

4.5 (96) · $ 17.50 · In stock

I would like to print the outer contour without extraction, and after that print the straight lines between the contour. I attached a picture how Cura does the slicing. It does several extractions

An open-source platform for 3D-printed redox flow battery test

ultimaker cura - How to print a part of the model using the same

Cura Slicer - Outer Before Inner For Better Dimensional Accuracy

Rene K. Mueller

Support - Makerlab

Top/Bottom pattern ignored when using spiralize outer contour

Cura: printing without shell or infill only? - UltiMaker Cura

Logo on outside wall disappearing when slicing in certain

Logo on outside wall disappearing when slicing in certain

Any reason Cura decides to break up a continuous line? : r/Cura

An open-source platform for 3D-printed redox flow battery test

Selecting the Correct 3D Printing Infill Pattern in Cura

Cura: printing without shell or infill only? - UltiMaker Cura