4.7 (363) · $ 19.99 · In stock
I’ve been happily printing for a while now with my Wanhao Duplicator i3 using PLA but a recent problem has occurred wherein, during the initial stages of a print with a large base surface area, the first layer has not stuck to the raft. This produces a surface effect similar to the gills of a fish, where, in one direction, the surface bows and parts of the filament stick up proud of the raft about 3mm high, forming raised ridges open on one side, at regular intervals. This obviously greatly int
UltiMaker Cura - Build plate adhesion settings
3D print not sticking to bed. Here are solutions!
First Layer Adhesion / Warping Help with Specific Print - Improve
Resin 3D printing raft: what you need to know
Getting Started with 3D Printing Using Tinkercad - SparkFun Learn
First layer not adhering to raft - can anyone help? - 3D Printing
First layer not adhering to raft - can anyone help? - 3D Printing
Resin 3D printing raft: what you need to know
The correct resin 3D printing raft settings
Why did my raft go down perfectly but not the first layer on the
ultimaker cura - Part not adhering to the raft - 3D Printing Stack
3D Printing Raft vs Brim vs Skirt: The Differences - FacFox Docs
5 Simple Steps to a Perfect First Layer
Raft silhouetting
First layer printed on the raft isn't sticking - ABS – Print tips